1. Manuals
  2. Brands
  3. Duratool Manuals
  4. Test Equipment
  5. D03480
  6. Manual

Duratool D03480 Manual

Wiring tracker and tester
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
D03480
WIRING TRACKER AND TESTER
D03480

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the D03480 and is the answer not in the manual?

Questions and answers

Related Manuals for Duratool D03480

Summary of Contents for Duratool D03480

  • Page 1 D03480 WIRING TRACKER AND TESTER D03480...

  • Page 2: Table Of Contents

    Table of Contents Please read the manual carefully before using this equipment Overview ..............01 • Please do not place the device in a location that is dusty, Keypad display and f eatures ......01 ° humid, or hot (above 40 Product Operation ..........

  • Page 3: Overview

    Overview D03480 is a new generation to offer digital and analog signaling all in one network toner and probe. It has three modes for options to track cable like digital mode, analog mode and PoE mode. That means it's equipped with the most powerful cable location technologies for any work environment.

  • Page 4: Product Operation

    Product Operation 1.1 Possible results Turn on the device and enter the below main Menu Only if a cable exsits short circuit, no matter it exsits cross, breakage or not,the testing result will only display "Short" □□� IIID IIID III=I�c=> information.

  • Page 5: Length Measurement

    mode on receiver accordingly. After that, hold the receiver to 2. Length measurement locate cable at the other end, the loudest voice is the correct one. Connect one end of cable to "Length/Port flash" port, disconnect the cable at far end, choose "Length" on the main SCAN SCAN SCAN...

  • Page 6: Port Flash & Switch Details Testing

    6. Setting 4.2 Non-standard PoE device If the PoE device is non-standard, it can also test POE voltage, 6.1. Backlight setting power supply polarity, power supply mode, but it can't tell the Adjust the backlight time among 15s, 30s, 60s, on, and off. type of PSE, just display "Non standard".
  • Page 7 Battery type 3 x 1.5V AAA Sensitivity adjustable Battery type 1 x 9V 6F22 PP3 Note: If the emitter uses a rechargeable battery, it can be charged through the Type-C port of the emitter.

  • Page 8: Faq

    9.FAQ Result Reason or solution Check whether the cable ends are well connected Different testing results for one same cable Keeps the ports clean Connects to wrong port, "Length/Flash" is the correct one. Length measured 0.0m Make sure the tested cable length is 2.5m-200m Connects to wrong port, "PoE"...

Table of Contents