Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for Atlanta O-300
Summary of Contents for Atlanta O-300
- Page 1 VEHICLE TRACKING DEVICE CAN Protocol GNSS Battery...
-
Page 2: Table Of Contents
Table Of Contents Introduction Acronyms & De nitions Know Your Device Technical Speci cation Navigation Cellular Network Power Operating Environment Key Features LED Indications Commands Precaution Mandatory Requirements Pre-installtion Instruction Device Orientation Mechanical Overlay Installation Steps Commands Con guration Commands 7.1.1 SMS Commands Details 7.1.2... - Page 3 Functionality Commands 7.2.1 GET GPS 7.2.2 Memory Data 7.2.3 7.2.4 Factory Reset Troubleshooting GPRS STATUS Troubleshooting Table Copyright Notice...
-
Page 4: Introduction
1. Introduction e OBD based plug-and-play GPS tracker combines anti-theft, fault diagnosis, monitoring, alarm rst aid and tracking functions with a new integrated product. Compact appearance, embedded GSM module, and GPS module can instantly monitor and record vehicle speed and position, support regional fence and abnormal alarm, SMS short message channel, remote monitoring, vehicle location management, vehicle fault warning, vehicle physical examination, and fuel... -
Page 5: Technical Speci Cation
4. Technical Speci cation Navigation GNSS GPS, AGPS, QZSS, GAGAN, GLONASS Channels 22 Tracking / 66 Acquisition Channel Sensitivity -165dBm Acceleration Accuracy 0.1 m/s Velocity Accuracy < 0.1m/s Hot Start < 1sec Warm Start < 30sec Cold Start < 31sec Cellular Network Band 2G 850/900/1800/1900MHz... -
Page 6: Key Features
Key Features GNSS & GPS Antenna Internal High Gain Antenna Indicators 3 LED's (Charging, GSM, GPS) Micro SIM Memory 6000 Packets Page 6... -
Page 7: Led Indications
(ii) e O-300 device should not be installed at a location which can be exposed to water or rain. Take care of water splash to and High voltage to O-300, while vehicle servicing. (iii) Pay special attention to the amount of remaining credit & expiry date of SIM card. -
Page 8: Pre-Installtion Instruction
6.3 Pre- Installation Instructions: It is advised to use the wire stripper to peel the wires to prevent the wire damage. (ii) Vehicle components must be functioning perfectly during, before & after the installation. (iii) All wired connections should be covered with insulation tapes. Use cables ties to keep wires and device together. -
Page 9: Installation Steps
O-300 would accept commands from any number if the password provided is correct. e password is a four digit number. e users can change the password of their device. O-300 would reply to all commands send by user. Example: - e command format would be Command <password>... -
Page 10: Sms Commands Details
XXX means digits from 001-999 H stands for hour, M for minutes and S for seconds. Example – when we send the command WEBSTART002M<6906>, O-300 will start sending the data to web server at 2 minutes interval. 7.1.4 Enable Distance Based Tracking In Distance based tracking, the device will generate data packets after covering a set distance and change in angle of more than 30 degrees. -
Page 11: Tcp Server Setting
7.1.5 TCP Server Settings To Port e Device To A Server: Command to port the O-300 to the rst server (with IP and PORT) #SERVERCHANGE::IP::PORT;<password> Eg.: #SERVERCHANGE:: 196.168.175.12::20000;<6906> is command would point O-300 to the server with IP=196.168.175.12 and Port= 20000... -
Page 12: Functionality Commands
Functionlity Commands 7.2.1 GET GPS To get GPS data for one time in SMS Send “GETGPS<password>” to O-300. Response: • If the GPS satellites are unreachable, you will receive “GPS NOT FOUND” • If the GPS satellites are reachable, you will receive Web link to view... -
Page 13: Troubleshooting
8. Troubleshooting 8.1 GPRS STATUS GPRSSTATUS<password> is command is used to get the complete status of the device, and the command format is GPRSSTATUS<6906>. Description of the reply Entries Description Remark Current network Distance based tracking Set distance would br e shown here with DBTON DBTON/OFF SOFF Sleep status... -
Page 14: Troubleshooting Table
"WRONG COMMNAD" command may be invalid. Please recheck the command phrase and resend. No response from O-300: Check your balance in case of Pre-Paid connection. Check the network status. (No Or weak network connection could be the reason) Resend the desired commands again. -
Page 15: Copyright Notice
Atlanta Systems Pvt. Ltd. unless such commitment is Expressly given in a separate document. Atlanta Systems Pvt. Ltd © copyright notice and statement that, “No Part of this document may be Reproduced without the prior written consent of Atlanta Systems Pvt. Ltd.
Need help?
Do you have a question about the O-300 and is the answer not in the manual?
Questions and answers