Hartke LOOP HL77 Manual page 7

Operating the HL77
7
To select the Stop Mode, press the STOP MODES button before or during playback. Each time you press
the STOP MODES button, it will cycle through each Stop Mode.
If you choose " " or " " the PLAY indicator will start flashing when you double-press the footswitch
until the audio has stopped.
If you want the loop to stop instantly in either " " or " ", quickly press the footswitch again while
the PLAY indicator is flashing.
Saving a Loop
Once you have created a loop, you can save it to one of the pedal's 99 memory locations. Each memory
location and loop can be as long as you want it to be until it reaches the memory limit of the pedal. The
HL77 has 4GB of memory which is equivalent to 6 hours of recording time.
After you have recorded a loop, short press the SAVE button, " " will start flashing on the display.
Press the PATTERN UP or DOWN buttons to choose an empty memory location (remember to select
a memory location that does not have a dot in the lower right corner of the display). Once you have
selected a memory location, press the SAVE button again to confirm and write the recording the internal
memory. To discard an unsaved loop, press any button besides the SAVE or PATTERN UP and DOWN
buttons.
When saving a loop, all the data including recordings, Stop Mode, tempo and the selected rhythm
pattern will be saved.
Note: The Auto Recording Mode will not be saved.
Note: You cannot save a loop to a memory location that already has data.