Recording A Phrase - Hartke LOOP HL77 Manual

Operating the HL77
Selecting a Memory Location
Press the PATTERN UP and DOWN arrows to cycle through the 99 memory locations.
The display shows the current memory number. A dot in the lower right corner of the display
means the current memory location contains saved data. If there is no dot, the location has
no data and can be used to create a new loop.
During playback, if you switch to another memory location, the number of the selected phrase will start
to flash. When the current loop reaches its end, the selected loop will start playing.
Note: There is no gap in the transition between the phrases, which makes the HL77 perfect for creating
complete backing tracks for songs.

Recording a Phrase

Press the footswitch to start to record a loop.
The REC indicator will light red when the pedal is recording.
Auto Recording Mode
Auto Recording Mode lets you start recording the moment the pedal detects an input signal.
To set the memory location to Auto Recording Mode:
1. Select an empty memory location.
2. Press and hold the STOP MODES button for 2 sec, "
3. Press the STOP MODES button while the display is flashing to change it to "
Recording Mode.
" will start flashing in the display.
4
" to enable Auto