Table of Contents
Advertisement
en Basic settings
Basic settings
15 Basic settings
You can configure the basic settings
Basic settings
for your appliance to meet your
needs.
15.1 Overview of the basic
settings
Programme selector with programme
positions
Set the volume of the signal
2
at the end of the programme:
0 (off) to 4 (very loud)
Set the volume of the signal
3
tone emitted when the but-
tons are pressed:
0 (off) to 4 (very loud)
Set the minimum installation
4
protection of the appliance to
10 A (LO) or 13 A (HI).
Note: The values for the en-
ergy label were determined
with a minimum installation
protection of 13 A. If the in-
stallation protection is
changed to 10 A, the pro-
gramme duration and energy
consumption will be in-
creased.
→ "Consumption values",
Page 44
Display the number of started
5
programmes.
34
15.2 Changing the basic set-
Set the programme selector to po-
1.
sition 1. → Page 34
Press
2.
same time, turn the programme
selector to position 2.
a The display shows the current
value.
1
Use the programme selector to se-
3.
lect the required basic setting.
2
→ Page 34
3
To change the value, press
4.
Ready In .
4
To save the changes, switch off
5.
5
the appliance.
Cleaning and servicing
16 Cleaning and servi-
To keep your appliance working effi-
Cleaning and servicing
ciently for a long time, it is important
to clean and maintain it carefully.
16.1 Tips on cleaning and
Wipe down the
housing and the
controls with
nothing but water
and a damp
cloth.
Remove all de-
tergent residue,
spray residue or
other residues
immediately.
Leave the appli-
ance door open
after use.
tings
Iron Dry and, at the
cing
care
This ensures the
parts of the appli-
ance will remain
clean and hy-
gienic.
Fresh deposits
are easier to re-
move without
leaving any
residue.
This allows the
residual water to
dry, reducing
odours in the ap-
pliance.
Advertisement
Table of Contents
