Table of Contents
Advertisement
So that the programme currently
running is not cancelled, the pro-
gramme selector must be set to
the initial programme.
goes out on the display.
a
Basic settings
14 Basic settings
You can configure the basic settings
Basic settings
for your appliance to meet your
needs.
14.1 Overview of the basic
settings
Programme selector with programme
positions
Set the volume of the signal
2
at the end of the programme:
0 (off) to 4 (very loud)
Set the volume of the signal
3
tone emitted when the but-
tons are pressed:
0 (off) to 4 (very loud)
Display the number of started
5
programmes.
14.2 Changing the basic set-
tings
Set the programme selector to po-
1.
sition 1. → Page 33
Press
2.
same time, turn the programme
selector to position 2.
a The display shows the current
value.
Use the programme selector to se-
3.
lect the required basic setting.
→ Page 33
To change the value, press
4.
Ready In .
To save the changes, switch off
5.
the appliance.
Cleaning and servicing
15 Cleaning and servi-
1
To keep your appliance working effi-
Cleaning and servicing
2
ciently for a long time, it is important
3
to clean and maintain it carefully.
4
15.1 Base unit
5
The base unit is the accessible area
at the bottom of the appliance in
which you will find the heat ex-
changer.
Opening the base unit
Requirements
¡ The appliance has cooled down
for 30 minutes.
¡ The appliance door is closed.
Iron Dry and, at the
cing
Basic settings en
33
Advertisement
Table of Contents
