Communications Kit Output Connections - Kohler 6VSG Installation Manual

Connection
Input 1
Input 2
Output 1 (Relay 1)
Output 2 (Relay 2)
Output 3 (Relay 3)
Output 4 (Relay 4)
Output 5 (Relay 5)
Output 6 (Relay 6)
Figure 15 PIM Factory Default Inputs and Outputs
1.8.7

Communications Kit Output Connections

The communications kit includes an interface board, which is factory-installed inside the generator set enclosure. The inputs
and outputs are factory-set to the settings shown in Figure 16.
The outputs are factory-wired from the circuit board to terminal blocks in the customer connection area. Do not attempt to connect
directly to the interface board. The output contacts are normally open (NO); outputs close on activation. Connect customer
equipment to the outputs at the terminal blocks as shown in Figure 16.
Connection
Input 1
Input 2
Output 1 (Relay 1)
Output 2 (Relay 2)
Output 3 (Relay 3)
Output 4 (Relay 4)
Output 5 (Relay 5)
Output 6 (Relay 6)
Figure 16 Communications Kit Factory Default Inputs and Outputs
Output connections
(6 outputs)
Figure 17 Communications Kit Output Connections
24
PIM Settings
None
None
Run
Common Fault
Low Battery Voltage (Programmable)
Not in Auto (Programmable)
Cooldown (Programmable)
Normal Source Failure (Programmable)
Communications Kit
Fuel Pressure
Enclosure Intrusion Alarm
Run
Common Fault
Battery Voltage
Fuel Pressure Low Warning
Enclosure Intrusion Alarm Warning
Reserve Oil Empty (oil makeup kit required)
commConn
GM85956E
TP-6842 9/21