Replacing The Oven Light Bulb - Zanussi GC5557 Instructions For The Use And Care

(ii) Extended by using a B.E.A.B.
approved 3-way sealed flex connector
with integral flex clamps.
DO NOT EXTEND THE CABLE USING
PLASTIC OR CERAMIC CONNECTION
TERMINAL BLOCKS AND/OR
INSULATION TAPE OR EXTEND OR
REPLACE WITH CABLE HAVING A
LOWER TEMPERATURE RANGE OR
CURRENT CARRYING CAPACITY.
ALL EXTERNAL WIRING BETWEEN
THE APPLIANCE AND THE
ELECTRICAL SUPPLY SHALL COMPLY
WITH I.E.E. REGULATIONS.
Fit a 3-pin 13 amp plug to the end of the
cooker cable. Connect the wires as
follows:
Brown to the Live Terminal.
Blue to the Neutral Terminal.
Green and Yellow to the Earth Terminal.
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
The wire which is Green and Yellow
must be connected to the terminal in the
plug which is marked with the letter 'E'
or by the earth symbol ± or coloured
Green or Green and Yellow.
The wire which is coloured Blue must
be connected to the terminal which is
marked with the letter 'N' or coloured
Black.
The wire which is coloured Brown must
be connected to the terminal which is
marked with the letter 'L' or coloured
Red.
Fit 3 amp fuse to the plug fuse holder.
Ensure that the supply cable cannot get
caught by the stability bracket.
Should the ignition system fail to work
there may be a fault with the electrical
supply. First, check the socket by trying
out another electrical appliance in it, if
that works correctly renew the fuse in the
plug of the appliance.
Repetitive failure of the fuse indicates
that there is a fault on the appliance
which must be rectified. Do not replace
with a fuse of a higher rating than
3 amps. Do not attempt further electrical
operation. Isolate from the electrical
supply and inform the installer of the
fault on the appliance.
Replacing the oven
light bulb
The type of bulb required is a 15 watt
small Edison Screw.
1. Disconnect from the electricity supply.
2. Open the oven door, remove the oven
shelves.
3. Unscrew the bulb cover in an anti¬
clockwise direction.
4. Unscrew the bulb in an anti-clockwise
direction.
5. Fit the new bulb by screwing in a
clockwise direction.
6
. Replace the glass and seal by screwing
in a clockwise direction.
7. Replace the oven shelves.
8. Restore the electricity supply and
adjust the clock as necessary (Page 13).
7