Advertisement
How to Connect
onnections and Initial Setup
Initial Setup
for ANT./Cable - VCR - TV
( Connect the Cable from
Antenna/Cable to the IN
FROM ANT. terminal on VCR.
(2) Connect the OUT TO TV
terminal on the rear of VCR
to the ANT. IN terminal on
TV using the RF Cable
(included accessory).
VCR
IN FROM ANT.
D iN trom
X
ANT/CABLE
OUT TO TV
e
VHF/UHF
Initial Setup
for DSS/Cable Box-VCR-TV
@ Connect the OUT Jack on
your cable box to the IN
FROM ANT. terminal on the
VCR with an RF cable.
@) Connect the OUT TO TV
terminal on the rear of VCR
to the ANT. IN terminal of
TV using the RF Cable
(included accessory).
How to do Initial Setup
1 Press VCR* for VCR mode. Turn
the TV on and set it to channel 3.
Turn VCR on.
When VCR is turned on the first
time, SELECT LANGUAGE
screen
appears.
SELECT
LANGUAGE
PRESS
CH
à:
ENGLISH
PRIMIA CH
¥ ; ESPAÑOL
PP.
VCRITV
; FRANCAIS
TO CHANGE
VCR' S OUTPUT
CH,
PRESS
ACTION KEY.
If screen does not appear, check
connection between VCR and TV
and, if TV is tuned to channel 3, try
switching it to channel 4.
When you want to change the output
channel of VCR, please refer to VCR's
Output Channel on page 11.
If wrong language is set, do "Reset All
VCR Memory Functions" steps on
page 9.
+
VHF/UHF
3 Press CHA to select English.
or
Press CHY to select Spanish.
or
Press VCR/TV key to select French.
When one of above keys is pressed,
CHANNEL/CLOCK AUTO SET screen
appears.
[VCR
| CLOCK [CHANNEL |
CRANNEL/ CLOCK AUTO SET
CONNECT
ANTENNA CABLE
AND
IF YOU USE A CABLE
BOX, TUNE
IT TO YOUR
LOCAL PBS CH
THEN...
PLEASE
PRESS CH UP KEY
If you use a cable box, turn it on and set it to
the Public Broadcasting
Station (PBS)
channel in your time zone. If you use DSS
receiver, it must be turned off.
WARNING
When using "Nut type" RF coaxial cables,
tighten with fingers only. Overtightening
may damage terminals.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Advertisement
