Installation Instructions; Door Swing - GE UNC15NJ II Technical Service Manual

Door Swing

The door can be attached to open with hinges on
the left or right. Retain all screws for reuse.
To change door swing:
1. Remove the innermost screw holding each
hinge to the cabinet. Loosen the other screw.
Remove
Remove
Upper Hinge Bracket Upper Hinge Bracket
2. Slide the hinges to the side and remove the door
from the cabinet.
3. Remove the door gasket.
4. Remove the hole plugs from the hole covers.
Hole Plug
Hole plug
Gasket
Gasket
Cover
Cover
5. Remove the screw holding the hole cover to the
6. Remove the screws holding door panel to the
door, and separate the panel from the door.
7. Remove the upper hinge and move it to the
door's opposite side, bottom location. Secure
using the original screws.
8. Remove the original lower hinge and move it to
the door's opposite side, upper location. Secure
using the original screws.

Installation Instructions

9. Remove the screw holding the hole cover to the
10. Remove the screws holding the door panel to
11. Remove the upper hinge and move it to the
12. Remove the original lower hinge and move it to
Top Panel
Top Panel
13. Slide the hinge covers from the hardware packet
Loosen
Loosen
14. Attach the side covers from the hardware
NOTE: If the unit is being built-in, a screw can be
used to secure the unit to the cabinet in place of
installing the side covers.
Hinge Cover
Hinge Cover
15. Return the kick plate and front service panel to
– 18 –
door, and separate the panel from the door.
door's opposite side, bottom location. Secure
using the original screws.
the door's opposite side, upper location. Secure
using the original screws.
over each hinge.
covering over the adhesive and placing it over
the side of the hinge.
Side
Side
Cover
Cover
their original positions and attach to the cabinet
using the original screws.