Related Manuals for Häfele 408.24. Series
Summary of Contents for Häfele 408.24. Series
- Page 1 Mounting Instructions Item No.: 408.24. Series XL Pocket Door Slide System Finish: Black Electroplated Zinc Maximum Door Weight: 35 lbs. Maximum Door Size: 60”Height x 24” Wide...
- Page 2 (B) Pre-mounted Spacer Tabs 1 Mounting the slides Attach slides (A) to side panels using (8) Trusshead screws (013.03.304) as shown. Top and bottom locations are determined by pre-mounted spacer tabs (B). This assumes cabinet is square and parallel. Make sure slides are absolutely parallel. Backset is measured from front edge of cabinet to front edge of rollers: Trusshead Screws...
- Page 3 4 Door adjustments Adjust out any sag in the door using the cable adjuster (E) Do not over tighten cable. Cable should only have light tension applied. Make further adjustments using adjusting screws on hinge and mounting plates. (see diagram) Test ease of operation by sliding door in and out.
- Page 4 Pocket width required Door Type Pocket Width “X” using up to a maximum door Inlay doors 64mm (2 1/2”) size of 1 1/4” (32mm) Overlay doors 50mm 35 mm Cup Hinge Pocket Width Inlay doors 45mm (1 3/4”) Slide “X” Door Side Panel Accessory Pack Contents...