Filter Operations; Normal Operation; Maximum Working Pressure; Maintain The Pressure Gauge - AquaStar PIPELINE FILTERS PLF27000 Installation And User Manual

INSTALLATION INSTRUCTIONS
Step 4: While holding the Locking Ring in place with one hand,
use the other to rotate the filter dome by holding and aiming
the Air Relief Valve where you intend the water to spray. DO NOT
AIM AIR RELIEF VALVE AT ELECTRIC EQUIPMENT OR PUMP
CONTROLS. If the Dome rotates with Locking Ring when being
held with one hand, or you need two hands to rotate the Locking
Ring, alternate using both hands to rotate the Locking Ring and
then the Dome until it is where you want it (E).
Step 5:
Hold the Air Relief Valve (as needed) while continuing to
rotate the Locking Ring clockwise from (D) another ¼ turn, until
you feel the O-ring engaging the Filter housing (F).
Step 6:
Using both hands, continue rotating the Locking Ring
clockwise another 1/3 turn, sealing the O-ring and fully locking the
filter together (G). It is fully locked when you feel the large handles
"click" and the Locking Ring hits a hard stop. The Locking Ring handles MUST be back where you started, at 3 and 9
o'clock. THE LOCKING RING MUST COMPLETE ONE FULL TURN TO FULLY CLOSE AND LOCK THE FILTER.

FILTER OPERATIONS

Normal operation

This filter operates under pressure. When the lock
ring is installed properly and operated without air
in the water system, this filter will operate safely.
See Figure 4 for system operation overview.
Maximum working pressure is 50 psi
The maximum working pressure of this filter is 50
psi. Never subject this filter to pressure in excess of
this amount - even when conducting hydrostatic
pressure tests. Pressures above 50 psi can cause
the lid to be blown off, which can result in severe
injury, death or property damage.

Maintain the pressure gauge

The pressure gauge is the primary indicator of
how the filter is operating. Maintain your pressure
gauge in good working order.

When to clean the filter

Clean your filter when pressure reads 10 psi or higher than the original starting pressure. Your filter pressure reading
will increase as it removes debris from your pool. However, this buildup of pressure will vary due to different bathing
loads, temperature, weather conditions, etc.
MY ORIGINAL STARTING PRESSURE IS ___________ psi (pounds per square inch).I SHOULD CLEAN THE FILTER
CARTRIDGES AT __________ psi.
8 Cartridge Filter Manual
CONTINUED
- AquaStar Pool Products
STEPS 4 & 5
F
"HOLD
IN PLACE"
D
Figure 4
G
"CLICK"
LOCK
&
STOP