Page 1
Coco i-Size Baby Car Seat 40-87cm Max Weight 13kg Approved under European ECE R129/03 Manufactured in accordance with ISO9001:2015 When using the child car seat, please read the user guide carefully and keep it properly.
Page 2
The User Guide Notice: 1.This is Universal Belted Enhanced Child Restraint System. It is approved accord-ing to UN Regulation [No. 129], for use primarily in "Universal seating positions" as indicated by vehicle manufacturers in the vehicle user’s manual. 2.If in doubt, consult either the Enhanced Child Restraint System manufacturer or the retailer.
Safety Warning 1.Before installs and uses this child-safety chair, please read the user guide carefully, because incorrect installation is very dangerous. 2.This child-safety chair are suitable for children weighing 0-13 kilograms. It can only be installed rearward-facingly. 3.This child-safety chair cannot be installed in seating position with airbag. 4.This child-safety chair is only suitable if the approved vehicles are fitted with 3-point safety-belts with retractor , approved to GB 14166 or ECE Regulation No.16.
Child-safety Chair Notes 1. Button 6. Handle 2. Adjuster Strap 7. Sunshade 3. Cloth Cover 8. Front green belt guide hook 4. Buckle 9. Slot for Vehicle Shoulder Strap 10. Headrest adjustment button 5. Shoulder Strap 11. Sponge pad(To use, place the pad on top of the cloth cover) Release Y-shaped Belts PRESS 1.Open the buckle (press the red button of the buckle);...
Y-shaped Belts click! Tighten the harness Step1. Put the two buckle latches together. Figure 1 Step2. Put locked latches into the safety buckle, When you hear the "click" noise, it means that the safety buckle has been completely locked. Figure 2 Attention! When inserting locked latches into buckle, make sure to hear a crisp "click"...
Y-shaped Belts Release Y-shaped Belts You can release your child from the child-safety chair as long as you press the button on the buckle, and make sure the buckle latches are not tripping or hooking your child's clothes. Adjust the shoulder straps before installing the child-safety chair The position of the shoulder straps is adjusted to the height of the headrest.
Child-safety Chair Installation The type of vehicle belt needed: The child seat can only be installed on the front or back seats equipped with shoulder and lap straps. This child car seat is only suitable when the vehicle seat is equipped with 3-point safety belts with retractor , approved to GB 14166 or ECE Regulation No.16 shoulder strap...
Attentions for using the vehicle DANGER! If there is an accident and there is a lot of momentum, do not hold your child on your leg with car seat belt. Do protect your child! Make sure that the child-safety chair is installed rearward-facingly.
Installation Steps 1. Install the child car seat on the vehicle seat rearward-facingly,and ensure that it is close to the backrest of the vehicle seat. Figure 1 2. Put the lap strap of vehicle belt across the slots which is in the child car seat and and insert the latch of the vehicle belt into its buckle.
Adjust the Position of Handle If you want to adjust the position of the handle , press the red buttons on both sides of the handle and adjust it to the position you want. As the following figures: There are 4 positions. (i)Feeding/non-rocking position.
Daily cleaning of the child-safety chair Wipe with clean water with a sponge. Do not use any chemical cleaner,it will cause partial corrosion of seat. Babymore Unit C2, Zenith Industrial Estate, Paycocke Road Basildon, Essex, SS14 3DW. Telephone: +44 (0)20 3475 5588 Email: customerservices@babymore.co.uk www.babymore.co.uk...