Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury FrOM FLyinG DeBriS:
Wear long pants, long sleeves and protective footwear. Wear anSi-approved
safety goggles, dust mask, hearing protectors, and gloves.
charging Battery pack
Charge Battery Pack according to the instructions included with the Charger.
Operation
tO aVOiD SeriOuS inJury anD prOperty DaMaGe:
inspect the area before using the Blower. remove all hard objects from work area.
Do not blow debris in the direction of people, animals or property.
use both hands when operating Blower.
1. Assemble Blower according to
Assembly Instructions on page 7.
cautiOn! tO preVent inJury: Do not use
the Blower without the tube attached. the tube
helps prevent contact with internal moving parts.
cautiOn! tO preVent inJury: Wear anSi-
approved safety goggles during use.
note: Rake or sweep to loosen debris if necessary.
2. Make sure Switch is in the OFF‑position (O),
then slide Battery Pack into slot on back
of Blower until it clicks into place.
Page 8
For technical questions, please call 1-888-866-5797.
3. Hold Blower with both hands, with the
Tube several inches off the ground.
4. Press the Switch to either the i or ii setting,
depending on the desired speed.
5. Sweep from side to side.
6. Turn Switch to O when done.
7. When finished, to prevent accidents:
• Remove battery pack.
• Wipe external surfaces of the appliance
with clean cloth. Store in an indoor
dry area out of reach of children.
Item 64942