Verifying Post-Installation Connectivity; Electrical And Environmental Specifications - HP 503H Installation Manual

Software
For instructions on choosing operating modes and initial software configuration, refer to the AP Software Quick
Start Guide.
HPE Aruba Networking access points are classified as radio transmission devices, and are subject to government
!
regulations of the host country. The network administrator(s) is/are responsible for ensuring that configuration
and operation of this equipment is in compliance with their country's regulations. For a complete list of
approved channels in your country, refer to the HPE Aruba Networking Downloadable Regulatory Table at
www.arubanetworks.com/techdocs/DRT/Default.htm.

Verifying Post-Installation Connectivity

The integrated LED on the access point can be used to verify that the access point is receiving power and
initializing successfully (see
further details on verifying post-installation network connectivity.

Electrical and Environmental Specifications

For additional specifications on this product, please refer to the product data sheet at www.arubanetworks.com.
Electrical
Ethernet:

E0: 10/100/1000 Base-T auto-sensing MDI/MDX

IEEE 802.3i (10 Base-T) IEEE 802.3u (100 Base-T). IEEE 802.3ab (1000 Base-T)

Power:

Power over Ethernet IEEE 802.3af

12V DC power interface, support powering through AC-to-DC power adapter

Maximum power consumption: Refer to datasheet

If a power adapter other than the HPE Aruba Networking-approved adapter is used in the US or Canada, it
should be NRTL listed, with an output rated 12V DC, minimum 1.045A, marked "LPS" and "Class 2," and suitable
for plugging into a standard power receptacle in the US and Canada.
Environmental
Operating:

Temperature: 0°C to +40°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport:

Temperature: -40°C to +70°C (-40°F to +158°F)

Humidity: 5% to 93% non-condensing

!
For indoor use only. The access point, AC adapter, and all connected cables are not to be installed outdoors. This
stationary device is intended for stationary use in indoor temperature controlled and weather-protected
environments (ETSI Class 3.1per ETSI 300 019).
HPE Aruba Networking 503H Hospitality Access Points
Table 1 and Table 2). Refer to the Access Point Software Quick Start Guide for
| Installation Guide
9