CARE AND CLEANING
To keep your ice tasting fresh and your ice maker looking great, we recommend
cleaning your ice maker once per week.
•
Stop the ice-making cycle by pressing the "ON/OFF" key, unplug the ice maker
from the wall outlet and allow it to warm up to room temperature.
•
If residual water is found in the ice tray, gently push the ice tray back so that all
water drains into the water reservoir.
•
Move the appliance forward to a place 60 mm away from the working table and
open the drain plug to drain out excess water (see Fig. 1, Fig. 2 and Fig. 3).
•
Check and make sure the drain plug must be properly closed. Fill the water
reservoir with clean water, press 'SELECT' until the 'CLEAN' indicator flashes,
then press the "ON/OFF" key , whereafter the pump will start to pump water and
keep running for 6 minutes, and it will enter into standby condition after running
for 6 minutes, finally, open the drain plug and empty the water.
•
Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.
•
Clean the ice maker interior with a soft cloth soaked with warm water and vinegar,
then rinse with clean water and then drain all the water.
•
Replace the drain plug well in position. Wash the ice basket and ice scoop in warm
soapy water. Rinse and dry.
•
Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing
agent, if necessary.
NOTE! Do not use any organic solvent, boiled water, detergent, strong acid and
•
strong alkali etc. for cleaning.
•
NOTE! Do not clean the evaporator.
•
Please empty the water reservoir and dry it for storage if the ice maker is not
going to be used for a long time.
60
(Fig. 1)
6
Working table
Drain plug
(Fig. 2)
Drain plug
(Fig. 3)
Need help?
Do you have a question about the 900701420101 and is the answer not in the manual?