Get Started - RUSTA 900701420101 Manual

GET STARTED!

1. Unpack the appliance, then check and make sure that all the accessories including
ice basket and ice scoop etc. are complete.
2. Ensure the ice maker is level and on a stable table or platform to avoid malfunction.
3. The incline angle of the ice maker cabinet should not exceed 45° during
transportation or use. Do not turn the ice maker upside down. Doing so could
cause the compressor or refrigerating system to operate incorrectly. Please allow
time for the fluids in the compressor to settle after the ice maker is moved or
transported. Before using the ice maker for the first time, please wait for 2 hours
after the unit has been leveled and positioned in the proper place.
4. The appliance must be placed on a dry and level surface with sufficient ventilation,
far from heat sources such as ovens, heaters and corrosive gases. Leave about a
6-inch (15 cm) clearance on all sides of the ice maker for proper ventilation.
5. Do not fill the water reservoir with hot water. This can damage the ice maker.
It is best to fill the water reservoir with water at room temperature or lower.
Do not use the appliance in a very cold environment (lower than 5 ℃).
6.
7. Clean the appliance by following the operation of "CARE AND CLEANING"
before operating.
USE
CONTROL PANEL
Key (with indicator) Function
ON/OFF
POWER
ICE FULL
ADD WATER
S
L
CLEAN
SELECT
4
Start or stop the appliance.
Standby mode: "POWER" indicator blinks.
Working condition: "POWER" indicator lights solidly.
"ICE FULL" indicator lights up when the ice basket is full.
"ADD WATER" indicator lights up when the water reservoir is
lack of water.
The indicator lights up when select small ice.
The indicator lights up when select large ice.
"CLEAN" indicator lights up when the appliance needs to be cleaned.
Can select "S", "L" or "CLEAN" under standby mode,
after power on, can select "S" or "L".