RUSTA 900701420101 Manual page 5

Table of Contents

Advertisement

Available languages
  • EN

Available languages

1. Ensure that the drain plug at the bottom of water reservoir is properly closed.
2. Plug the ice maker into the wall socket, after which the "POWER" indicator blinks.
NOTE! Please allow the ice maker to rest for 30 minutes before attaching the
plug if it has been moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with tap water. NOTE! Do not fill above the MAX water
level mark.
5. Replace the ice basket and close the top lid.
6. Press "ON/OFF" key, and the "POWER"indicator lights consistently. At that time,
press "SELECT" key to select the ice size. If need to clean the appliance,
press "SELECT" key to select "CLEAN" function in standby mode.
7. The ice-making cycle will last approximately 7–9 minutes, depending on the
ambient temperature and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated
below the evaporator. Over the next 7–9 minutes ice forms on the evaporator.
Once this has completed, the ice tray will tilt backwards and the remaining
water in the ice tray is drained back into the water reservoir. The ice cubes are
then dropped from the evaporator and pushed forward into the ice basket by
the ice shovel. The ice tray will automatically move back into position under the
evaporator and start the next cycle.
9. The "ICE FULL" indicator will light up when the ice basket is full and then the ice
maker will stop the ice-making cycle automatically. Gently remove the ice from
the ice basket with the ice scoop. About 7.5 seconds later, the ice maker will restart
its ice making function automatically.
10. The "ADD WATER" indicator will light up when the water reservoir has a lack of
water and the ice-making cycle will stop automatically. At that time, remove the ice
basket and add water to the water reservoir, and then press the "ON/OFF" key again
to restart the ice-making cycle. The appliance will start working automatically after
about 20 minutes if the operator forgets to restart the appliance after refilling.
11. When you have got your desired amount of ice, stop the ice making cycle by
pressing the "ON/OFF" key and unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice maker to reach room temperature.
14. We suggest replacing the water every week. Please empty the water reservoir
if the ice maker is not used for a long time.
5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 900701420101 and is the answer not in the manual?

Questions and answers

Table of Contents