Table of Contents
Advertisement
• • • •
If you will not use your machine for a long time, unplug your machine,
close the water supply and leave the door open in order to keep the
inside of the machine dry and for prevention from unpleasant odour.
• • • •
As a result of the quality control procedures, a certain amount of
water may remain in your machine. This is not harmful for your
machine.
SECTION 2: INSTALLATION
You must pay attention to the following issues before using your washing
machine.
REMOVAL OF TRANSPORTATION SCREWS
• • • •
Transportation screws, which are located at the back side of the
machine, must be removed before running the machine.
• • • •
Loosen the screws by rotating counterclockwise by a suitable wrench.
(DIAGRAM-1)
• • • •
Remove the screws by pulling them.(DIAGRAM-2)
• • • •
The plastic parts located in the interior part of your machine will fall
down under the device.
• • • •
Lift your machine up slightly, pick up the plastic parts.
• • • •
If all of the plastic parts of screw groups have not fallen down; open
the door of your machine,move the drum until all plastic parts fall
down. Collect the parts that have fallen to the floor.
• • • •
To the holes where the transport screws have been removed, insert
the plastic transport screw taps found in the accessories bag.
(DIAGRAM-3)
• • • •
The transportation screws, that have been removed from the machine
should be kept in hand for any other transportation necessities.
DIAGRAM-1
ADJUSTMENT OF FEET
• • • •
Do not install your machine on rugs or similar surfaces.
• • • •
For your machine to work silently and without any vibration, it should
be settled on a flat, non-slippery and tough ground.
DIAGRAM-2
30
DIAGRAM-3
Advertisement
Table of Contents
