Panasonic ER-ATH Instruction Manual

INSTRUCTION
MANUAL
Conductive Tube Holder
ER-ATH
MJE-ERATH No.0098-37V
Thank you very much for using Panasonic
products. Please read this Instruction
Manual carefully and thoroughly for the
correct and optimum use of this product.
Kindly keep this manual in a convenient
place for quick reference.
1 OUTLINE
This product is used to fix the end of
the conductive tube (ER-AT50).
It also prevents the end of the con-
ductive tube from coming in contact
with a grounded object.
2 PART DESCRIPTION
Designation Quantity
H o d l r e A 1
H o d l r e B 1
H o d l r e C 1
H o d l r e D 1
Hexagon-socket-head bolt
2
[M3 (length 10mm)]
Hexagon-socket-head set screw
1
[M3 (length 3mm)]
3 ASSEMBLY PROCEDURE
1. Fix Holder B firmly with the accessory
hexagon-socket-head bolt [M3 (length
10mm)] on the mounting surface.
2. Assemble Holder A, Holder C and
Holder D as shown in the right figure,
and adjust in the direction of charge
removal with Holder A.
3. Fix Holder A, Holder C and Holder D
firmly by tightening the hexagon-
socket-head bolt.
4. Mount the conductive tube (ER-AT50)
in Holder A. When mounting, keep the
length of the conductive tube which
protrudes from Holder A within 10mm.
5. Tighten the accessory hexagon-
socket-head set screw [M3 (length
3mm)] to the extent that the conduc-
tive tube does not move. Take care
that if it is tightened excessively, the
conductive tube will deform, reducing
the charge removal capacity.
Holder B
Holder C
Holder A
Holder D
Hexagon-socket-
head set screw
0 to 10mm
Holder A (Reference for protrusion)
Conductive tube
ER-AT50 (Optional)
Panasonic Industry Co., Ltd.
1006, Oaza Kadoma, Kadoma-shi, Osaka 571-8506, Japan
https://industry.panasonic.com/
Please visit our website for inquiries and about our sales network.
Panasonic Industry Co., Ltd. 2024
April, 2024 PRINTED IN JAPAN