Front Speaker Impedance Selector Yw - Teac AG-V3020 Owner's Manual

Front Speaker IMPEDANCE SELECTOR
Caution:
To avoid damaging the speakers by inputting a
sudden high-level signal, be sure to switch the power
off before connecting the speakers.
Connect each speaker to the corresponding speaker
terminals, as shown below, as desired. For "Speaker
Installation", refer to page 21.
IMPEDANCE
SELECTOR
Lo)
AOR B: 82 OR MORE A+B: 82 OR MORE
AOR B: 42 TO LESS THAN 82
READ OWNER'S MANUAL BEFORE SETTING.
Speakers Terminals Speaker Impedance
Front Speakers
| FRONT
osetia nae
(main pair)
SPEAKERS A
IMPEDANCE
SELECTOR"
SPEAKERS 82, 162
Center Speaker | CENTER
SPEAKER
Connect the speaker cords to the speaker terminals as
shown in the following illustration.
Press the lever, insert the stripped end of the
cord, then release the lever so that the cord is
held securely.
Cautions:
1. Before setting this selector, be sure to switch the
power off.
In addition to this section, also refer to "SPEAKERS
Select Buttons" on page 14.
2.
After connecting front speakers, set the IMPEDANCE
SELECTOR switch according to the table below.
When using speakers A or speakers B separately.
Speaker Selector position
impedance
42,62 AOR B: 4Q TO LESS THAN 8Q
|
82,162 A OR B: 8 2 OR MORE
[o_|
When using speakers A and speakers B together.
Speaker Selector position
impedance
8Q,16Q A +B: 8 Q OR MORE
=|