Moto XFB Owner's Manual
Low-profile bed
Hide thumbs
Also See for XFB:
- Owner's manual (14 pages) ,
- Owner's manual (13 pages) ,
- Owner's manual (11 pages)
Related Manuals for Moto XFB
Summary of Contents for Moto XFB
- Page 1 OWNER’S MANUAL XFB/XSF/SFL Low-Prof ile Bed HEAD FOOT STOP LPB11WM Rev 10.0 08/2023...
- Page 2 Setup the power foundation without the bed frame. Take out all the accessories from the packaging and put Mattress Retainer Bar Accessories Box them aside. All electronics and components that need to Open the box lid. be installed are located in boxes under the foundation or attached to the frame.
- Page 3 WARNING! FAILURE TO FOLLOW THIS STEP WILL RESULT IN DAMAGE TO YOUR POWER FOUNDATION. PLEASE MAKE SURE YOU FOLLOW THE INSTRUCTIONS CAREFULLY BEFORE UNFOLDING YOUR POWER FOUNDATION. Remove the red plastic Turn the locking pin 90° in Remove the folding locking safety clip.
- Page 4 Uncoil the AC power cord, connect Insert the batteries into the DC power cord to the power the remote control. supply and then connect the power supply to the AC power source. HEAD FOOT A R D AC Power Source STOP D B O H E A...
- Page 5 Setup the power foundation with the bed frame and slat base. Take the bed out of the box, put it on the slat base, do not Uncoil the DC power cord. install any legs. Keep the bed folded. A R D A R D D B O D B O...
- Page 6 Install the mattress retainer bar one side after another. Make the bed completely flat with a flipping motion. A R D A R D D B O D B O H E A H E A DC Power Cord DC Power Cord Uncoil the AC power cord, connect the DC power cord to the Insert the batteries into power supply and then connect the power supply to the AC...
-
Page 7: Control Box
Electronics Quick Reference Guide If simultaneous operation of two foundations is desired, please follow the steps listed below. Sync Cord Sync cable is not required if both Model No.:****** WIRELESS RECEIVER adjustable bases are equipped with V2.0 ****** V2.0 or newer remote controls. If the Charger Power Cord bases are equipped with V2.0 remote controls, follow... -
Page 8: One Touch Button
Remote Control Instructions Pairing Remote The original remote that comes in the box is already paired to the foundation. No further action is required. In the event when the remote is not paired with the HEAD FOOT foundation, follow the pairing instructions below. Flat Position STOP STEP 1：... - Page 9 MotoSleep Mobile APP (Optional) Before you start. Switch on the pairing function on your mobile device. Make sure your MotoSleep Power Foundation is correctly connected and is power-on. MotoSleep Mobile APP is a mobile application to control the MotoSleep Power Foundation with The MotoSleep APP will automatically pair your MotoSleep Power Foundation once you start mobile devices.
-
Page 10: Headboard Bracket Installation Guide (Optional)
Legs Installation Guide Headboard Bracket Installation Guide (Optional) Headboard brackets are optional and not included. A 1/2” (13 mm) Leg Configuration Table socket and 1/2” (13 mm) wrench are required to complete the installation. (2) T-Brackets (8) M8*16 (4) Nuts (4) Washers (2) Headboard Brackets Configuration... - Page 11 Spacing Connector for TXL/T/CKS (Optional) Product Serial Number (Figure B) Install two spacing connectors to ensure the gap between the two Each power foundation has its unique serial number. The serial adjustable bases is consistent. number can be found on the metal (2) SPACING CONNECTOR (TXL/T/CKS ONLY) frame near the legs at the foot area.
Need help?
Do you have a question about the XFB and is the answer not in the manual?
Questions and answers