Blade Service; How To Sharpen The Blade - Hayter Double 3 Owner's Handbook Manual

MULCHING BLADE REPLACEMENT
A mulching mower is equipped with a special
mulching blade. If the mulching blade be-
comes worn or damaged, replace with an origi-
nal equipment mulching blade. A standard
blade will not mulch correctly.

BLADE SERVICE

WARNING: Before you inspect
the blade or the blade adaptor,
disconnect the wire to the spark
plug. If the blade hits an object,
stop the engine. Disconnect the
wire to the spark plug. Check the
unit for damage.
Frequently check the blade for wear or dam-
age such as cracks. Frequently check the bolt
that holds the blade. Keep the bolt tight. If the
blade hits an object, stop the engine. Discon-
nect the wire to the spark plug. Check the
blade adaptor for damage. Check for a bent or
damaged blade, a badly worn blade, or other
damage. Before you operate the unit, dam-
aged parts must be replaced with factory re-
placement parts. For safety, replace the blade
every two years. Keep a sharp edge on the
blade. A blade that is not sharp will cause the
ends of the grass to become brown. Remove
the blade as follows.
HOW TO REMOVE THE BLADE
WARNING: Before you remove
the blade, disconnect the wire to
the spark plug. The blade has
sharp edges. When you hold the
blade, use gloves or cloth mate-
rial to protect your hands.
1. Drain the fuel tank.
2. Lift the side of the mower that has the si-
lencer or spark plug.
3. Use a piece of wood to keep the blade
from rotating.
4. Remove the bolt that holds the blade.
5. Check the blade according to the "Blade
Service" instructions. Replace a badly
worn or damaged blade with a factory re-
placement blade.
6. Mount the blade with the curved edges to-
ward the housing. If the blade is upside
down, the blade will not cut correctly and
can cause an accident.
7. Fasten the blade with the original wash-
ers and bolt. Make sure the outside rims
of the Belleville washers are toward the
blade (Figure 16).
8. Tighten the bolt that holds the blade to a
torque of 30 foot pounds (47.5 Nm).
F−96498
MAINTENANCE

HOW TO SHARPEN THE BLADE

1. Sharpen the blade two times a year or ev-
2. If the blade is on the unit, do not sharpen.
(Continued following page)
20
Blade Adapter
Blade Adapter
Ó Ó Ó Ó Ñ Ñ
Ó Ó Ó Ó Ñ Ñ
Ñ Ñ Ñ Ó Ó Ó Ñ Ñ Ó Ó Ó Ó Ñ Ñ Ñ Ñ Ñ Ó Ó
Ñ Ñ Ñ Î Ñ Ñ
Flat Washer
Bolt
Î
WARNING: Always keep the bolt
that holds the blade tight. A
loose bolt or blade can cause an
accident.
Screwdriver
Ground
WARNING: Vibration is the result
if the blade is not correctly bal-
anced. A blade that is damaged
with cracks can break and cause
an accident.
ery 25 hours (Figure 17).
Remove the blade according to the in-
structions in "How To Remove The Blade".
Mulching
Blade
Belleville
Washer
Washer
Bolt
Mulching
Blade
Belleville Washer
Figure 16
Blade
File
Blade is balanced
when parallel to
the ground.
Figure 17