Table of Contents
Advertisement
Instructions for the user
Lift up the edge of the lower heating
element a few centimetres and clean
the bottom.
Put the pizza plate support back in
place, pushing it in until it hits the back
of the oven, and push it down so that
the heating element plate is embedded
into the base itself.
When the operation is complete, damp parts should be dried thoroughly.
8.5.1 Removing guide frames and self-cleaning panels
Removing the guide frames and self-
cleaning panels makes it easier to
clean the side parts, and it also needs
to be done whenever the assisted
cleaning cycle is used (only available
on some models).
•
To remove the guide frames, pull
the frame towards the inside of the
oven to unhook it from its housing
A, then slide it out of the seats at
the back B.
•
When cleaning is complete, repeat
the above procedures to put the
guide frames back in.
93
Advertisement
Table of Contents
