XMH300 Before drilling any holes, carefully inspect the area underneath and behind the Ÿ WARNING AND COMPLIANCE mounting surface where the device will be mounted to make sure it will not Important Safety Instructions interfere with existing wires, fuel lines, the fuel tank or any other objects that could be damaged.
If you take a few minutes to look through it, you'll learn how to use all the features of your new receiver for maximum enjoyment. Features Features of the XMH300 include: Dimmable LCD Backlit Control, TFT Display Ÿ...
XMH300 INSTALLATION Important Notes Before you begin, always turn off the batteries at the battery switch. If no battery Ÿ switch is installed on the vessel, you can disconnect the negative terminal from your battery. Before final installation, test the wiring connections to make sure the unit is Ÿ...
XMH300 WIRING DIAGRAM WIRE COLOR DESCRIPTION PURPLE RIGHT REAR SPEAKER(+) PURPLE/BLACK RIGHT REAR SPEAKER(-) BLACK RIGHT FRONT SPEAKER(+) GRAY BLACK ANTENNA GRAY/BLACK RIGHT FRONT SPEAKER(-) WHITE LEFT FRONT SPEAKER(+) BLUE YELLOW POWER AMP REMOTE AUX IN-RIGHT LEFT FRONT SPEAKER(-) WHITE/BLACK...
XMH300 BASIC OPERATION Audio Settings Press button (2) to access the audio settings. Rotate VOL/ENTER knob (4) to navigate through the following menu setting items: Equalizer (TREBLE, BASS), Loudness (ON/OFF), Balance & Fade and System Settings. Press VOL/ENTER buttons (4) to select the item. The unit will automatically exit the Audio Settings after seven seconds of inactivity.
Page 8
XMH300 Press VOL/ENTER knob button (4) to active the brightness control, then rotate VOL/ENTER knob (4) clockwise or counter-clockwise to adjust desire brightness from level “1” to “10” for night mode. Auto Mode Automatically switches illumination from Day mode to Night mode when illumination trigger lead is energized +12VDC.
XMH300 Save Presets TUNER OPERATION Rotate VOL/ENTER knob (4) to select desired location, press and hold VOL/ENTER button (4) to save current station in the selected desired Preset Stations. Delete Presets Rotate VOL/ENTER knob (4) to select the location, press and hold button (5) to delete the station saved in the location.
BLUETOOTH OPERATION button (4) to temporarily remove the Bluetooth connection. The connection can be The XMH300 includes built-in Bluetooth technology that allows you to connect this re-established trough your phone menu by selection the XMH300 for connection or unit to Bluetooth devices for streaming audio playback.
Page 11
Bluetooth mobile device when the power is restored. Press and hold VOL/ENTER button (4) to enter Bluetooth quick pair. The screen will display message “Verify Bluetooth is active on device and select: “XMH300” and will be available to pair for 2 minutes.
After downloading and installing the app on your device, pair your device to the check them for correct operation). Another method of suppression is the use of XMH300 as stated above for Bluetooth paring. Once your device is paired you can additional noise suppressors. These can be obtained from most CB/A radio or open the app and use with your XMH300 radio.
XMH300 SPECIFICATIONS TROUBLESHOOTING FM Tuner Problem Solution Tuning Range (USA)..............87.5 to 107.9 MHz If the power supply is properly connected to the vessel's accessory No power Tuning Range (Europe)............87.5 to 108.0 MHz terminal. but the engine is not on, switch the ignition key to "ACC"...
Need help?
Do you have a question about the XMH300 and is the answer not in the manual?
Questions and answers