SWJHD905 INTRODUCTION Thank You! Thank you for choosing a Jensen product. We hope you will find the instructions in this owner’s manual clear and easy to follow. If you take a few minutes to look through it, you’ll learn how to use all the features of your new Jensen receiver for maximum enjoyment.
Page 5
SWJHD905 Package Contents • SWJHD905 Radio • Radio Mounting Bracket • Headphone Mounting Bracket • Three (3) 10-16 x 3/4” Stainless Steel PPH Screws • Three (3) 10-32 x 5/8” Stainless Steel PPH Screws • Three (3) 10-32 Stainless Steel Hex Nuts •...
SWJHD905 INSTALLATION Mounting the Bracket Two options are provided for mounting the bracket (self-tapping screws or machine screws with nuts) to ensure a mounting option ideal for your mounting location. Avoid obstructing airflow to the rear cooling fins on the radio. NOTE: Mounting holes should be drilled to 7/32”.
SWJHD905 WIRING The wiring diagram depicts the wiring connections required for proper operation of the unit. Antenna Connector (Black Wire) 9-Pin Connector (Male) Note: Do not connect the red wire to a constant power connection. It should be connected to a vehicle connection with switched power, such as IGN or ACC.
SWJHD905 BASIC OPERATION 1. Power Press the power button (1) to turn the unit on or off. This button is also used to access the version number of the software. To briefly display the software version on the LCD, press and hold the power button for more than five seconds.
Page 9
SWJHD905 5. Auxiliary Input Function To connect a portable audio device (MP3 player, iPOD, etc.) to the SWJHD905, connect the headphone or line level output of the device to the 1/8" auxiliary input jack of the SWJHD905 (5b) using the audio patch cord (included). Pres AUX (5a) to select auxiliary input mode. 6.
SWJHD905 TUNER OPERATION 10. Select a Band Press AM/FM (10) momentarily to directly access tuner mode from any other function mode. When the unit is already in tuner mode, briefly press AM/FM to change between two AM bands (AM1 and AM2) and three FM bands (FM1, FM2 and FM3). NOTE: If the unit is programmed for European operation, the sequence will be MW1, MW2, FM1, FM2 and FM3.
Page 11
SWJHD905 13. Preset Stations Six numbered preset buttons (13) store and recall stations for each AM and FM band. To store a station, select a band (if needed), then select a station. Hold a preset button for three seconds. The current station will be stored, and the corresponding preset number will appear in the display. To recall a station, select a band (if needed).
SWJHD905 WEATHER BAND OPERATION 14. Accessing the Weather Band Press WB (14) to directly access the weather band mode from any other function mode. What is the NOAA Weather Radio? NOAA is a nationwide system that broadcasts local weather emergency information 24 hours a day. The U.S.
SWJHD905 TROUBLESHOOTING Problem Cause Corrective Action No power Vehicle ignition switch is not If the power supply is connected to the vehicle accessory circuits but the engine is not moving, switch the ignition key to “ACC”. The 3A fuse is blown Replace the 3A fuse.
Need help?
Do you have a question about the Jensen Heavy Duty SWJHD905 and is the answer not in the manual?
Questions and answers