Table of Contents
Advertisement
Available languages
Available languages
5
INSTALL HAND SHOWER
• Install SEALS (1) on both ends of the SPRAY HOSE (2) and
connect the one end with the hex nut to the TUB FILLER
ASSEMBLY (3) using an adjustable wrench. Hand tighten
the connection to the HAND SHOWER (4).
Note: When not in use, the HAND SHOWER (4) should
be seated in the HOLDER (5).
6
TEST INSTALLED FAUCET
• Move HANDLE (6) into "off" position and remove AERATOR (7).
• Turn on water supplies and check all connections for leaks.
• Operate HANDLE (6) on to off, hot and cold to flush water
lines thoroughly.
• Lift HAND SHOWER (4) from the holder and direct spray into tub.
Pull DIVERTER KNOB (8) and check HAND SHOWER (4) and
HOSE (2) connections for leaks.
• Push DIVERTER KNOB (8) in and place HAND SHOWER (4)
into HOLDER (5).
6
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
7
8
5
- 5 -
3
1
HEX NUT
2
6
M965140 REV. 2.2 (5/22)
4
1
Advertisement
Table of Contents
