INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test.
General instructions 1. INSTRUCTIONS FOR USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. IT MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE APPLIANCE. CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE APPLIANCE IS ESSENTIAL.
FATS AND OILS MAY CATCH FIRE. DO NOT COVER THE BOTTOM OF THE OVEN WITH ALUMINIUM OR TINFOIL SHEETS DURING COOKING AND DO NOT PLACE PANS OR TRAYS ON IT TO AVOID DAMAGE TO THE SURFACE. ALL COOKING OPERATIONS MUST TAKE PLACE WITH THE DOOR CLOSED.
BEFORE CARRYING OUT INSTALLATION/MAINTENANCE WORK, MAKE SURE THAT THE APPLIANCE IS NOT CONNECTED TO THE POWER GRID. THE PLUG TO BE CONNECTED TO THE POWER SUPPLY CABLE AND ITS SOCKET MUST BE OF THE SAME TYPE AND CONFORM TO THE REGULATIONS IN FORCE.
Page 5
WHILE IT IS IN OPERATION. DO NOT USE SPRAY PRODUCTS WHILE THE PRODUCT IS STILL HOT. The manufacturer cannot be held liable for damage to persons or things caused by failure to observe the above instructions, by interference with any part of the...
You can obtain the addresses of collection, recycling and disposal centres from your retailer or from the competent local organisations. Do not discard the packaging or any part of it, or leave it unattended. It can constitute a suffocation hazard for children, especially the plastic bags.
Instructions for the user 4. GET TO KNOW YOUR OVEN OVEN FAN LAMP RACK AND TRAY SUPPORT RUNNERS CONTROL PANEL...
Page 8
50° and 250°C. Adjustment is progressive so that the oven also operates at any intermediate value. The grill function can also be activated by turning the knob to the symbol (only in models with grill). ORANGE INDICATOR LIGHT When on, it indicates that the oven is heating up.
Page 9
(5 to 60). Adjustment is progressive so that the time can also be set to any intermediate value between these numbers. Upon completion of the cooking cycle, the knob automatically returns to 0, the oven turns off and a buzzer signal is set off.
• To prevent any steam in the oven from causing problems, open the door in two stages: keep the door ajar (about 5-6 cm) for 4-5 seconds and then open it fully. Note: As the oven door is opened, the fan, the heating elements and the steam dispenser are deactivated automatically.
Example AS DESIRED, BETWEEN 50°C AND 250°C The orange light comes on to indicate that the oven is heating up. Upon the set temperature being reached, the indicator light goes off. It switches on and off intermittently to indicate that the temperature is being kept constant.
To clean and preserve the stainless steel surfaces, always use only specific products that do not contain abrasives or chlorine-based acids. How to use: pour the product onto a damp cloth and wipe the surface, rinse thoroughly and dry with a soft cloth or chamois leather.
Page 13
Instructions for the user Cleaning the oven cavity To keep the oven in good condition it should be cleaned regularly at the end of the day. Let it cool first. Take out all removable parts. Removing the guide frames makes it easier to clean the side parts of the oven.
Page 14
Cleaning and removing the door glass To facilitate cleaning, it is possible to remove the door (see 7.2 Removing the door) and place it on a canvas, or open it and lock the hinges in order to extract the glass panels.
The oven may require extraordinary maintenance or replacement of parts subject to wear, such as gaskets, bulbs, etc. The following instructions describe how to carry out these minor maintenance operations. Before performing any operations, switch off the power supply to the oven.
Lower the door and once it is in place remove the pins from the holes in the hinges. Removing the door seal To permit thorough cleaning of the oven, the seal may be removed. Before removing the seal, take off the door as described above.
Page 17
If the oven is not working properly This product meets the current safety regulations in force for electrical appliances. To prevent safety hazards for users, all technical inspections or repairs must be carried out by qualified personnel. If the appliance is not working properly, before calling Customer Service, ensure that the procedures listed below have been performed.
If the appliance is connected to the electrical mains supply in a permanent manner, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm located near the appliance and in an easily reachable position.
The adjustment screws have a range of 10 mm. Steam outlet pipe Depending on the model, there are one or two outlet pipes on the back of the oven for releasing the steam produced during cooking. These must be left free of any obstruction.
Page 20
Stacked installation: a maximum of two appliances may be stacked. Rotate the appliance feet so that there is a gap of at least 30 mm between the two appliances; you should also set the top appliance back by 30 mm in relation to the appliance underneath.
Need help?
Do you have a question about the RFF43 and is the answer not in the manual?
Questions and answers