When The R Room Compressor (Nc1) Does Not Operate (R Room Inverter, Lc4_3050) - Samsung RF9000JC Manual

5. Self Diagnosis & Trouble Shooting
5-3. When the R Room Compressor (NC1) does not
operate (R Room Inverter, LC4_3050)
When the inverter PCB LED is ON,
it indicates that the compressor is
operating normally
Refer to the TEST Function
in this manual
The Forced Operating signal sound
should be checked
0 ~ 8 0 0 H z 5 0 % D uty Sig nal
Output
Check the wire harness Replace
the Main PCB
Replace the Inverter PCB
Start
10 minutes have passed since the
COMP was turned off
When Forced Operating mode is
activated, the COMP operates
Yes
The COMP operating signal (CN201
No
①↔③) is High (about DC 2-2.5V)
No
Is DC 15V applied to ZD501?
The CN101 Connector is Good
This document cannot be used without Samsung's authorization
No
Yes
Check after 10 minutes
No
The R-Sensor is Good
Yes
The temperature sensing part
Yes
of the MAIN PBA is Good
Replace the Main PBA or
Yes
Repair the connection
No
Yes
No
Replace the
Yes
R-Sensor.
No
Repair the
Yes
sensing part or
Replace the Main
Check the COMP wire Check the
Compressor Check the AC Power wire
PBA
102