Installation And Hook-Up - Smeg PL663WH Instruction Manual

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.
Position the appliance in the desired place of installation. The back or
sides of the dishwasher may be placed up against walls or other
furniture units. If the dishwasher is installed near a heat source, fit the
special insulating panel to prevent overheating and malfunction of the
appliance.
To ensure stability, install integrated or built-under dishwashers only
under continuous worktops, and screw them to the adjacent units.
To facilitate the installation procedure, the intake and drain hoses can be
positioned in any direction; make sure that the hoses are not kinked,
crushed or pulled too tightly.
Level the appliance on the floor using its adjustable feet. This operation
is essential for ensuring correct operation of the dishwasher.
Some models are equipped with only one adjustable foot at the rear,
which can be adjusted by turning the screw on the lower front part of the
appliance.
2.1 Water supply connection
Preventing the risk of clogging or damage: if the water pipe is new or
has not been used for a long time, before connecting to the water supply
check that the water is clear and free of impurities, to prevent damage to
the appliance. The dishwasher must always be connected to the water
system with new hoses; old or used hoses must never be reused.
CONNECTING TO THE WATER SUPPLY
Connect the intake hose to a cold water supply
with 3/4" gas thread, inserting the filter A supplied
with the dishwasher.
Take care to screw the hose firmly into place
with your hands and then complete by
tightening about 1/4 of a turn with pliers.
In dishwashers
ACQUASTOP device, the filters is already
fitted inside the threaded ring.
equipped with the
7