Smeg PGF30F Directions For Use Manual page 8

GB
The stainless steel anti-emulsion bowl
The stainless steel bowl constitutes a major component of your cold zone
fryer. The very special shape has been specifically devised and
designed, to maximise use of the characteristics of the cold zone and to
offer a maximum of safety, by avoiding any overflow during use of the
fryer. This exclusive model has been registered.
All the aesthetic characteristics which give the bowl its unique
appearance (curves, slopes, and differences of level) in fact correspond
to technical requirements. The principal objective was to overcome
bubbles of emulsion which occur on the sudden introduction of particles
of ice or water into the oil bath. This sometimes occurs when cooking
products which are frozen or which contain too much water.
There are 5 zones in this bowl :
The bottom of the bowl : All around the perimeter of the bottom of the
The cold zone
The hot zone
28
3. Assembly
bowl, an 11 mm channel has been inset, in
order to gather and store debris.
particular shape permits a reduction of 0.4
litre in the volume of oil in the cold zone.
Furthermore, the channel gives the bowl
excellent stability when taken out.
: The layer of oil located below the element is
not affected by any movement. Using all the
heating power, the temperature reaches 70° C
in the debris-collection channel.
: The hot volume of approximately 3 litres of
oil, permanently
movement, enables 750 grams of pommes
frites to be held at a single time without any
major cooling.
stirred by
This
convection