Installation Instructions - Smeg PGF30F Directions For Use Manual

GB
It is necessary to provide a bipolar cut-off device in your power supply
circuit, where the opening of the contacts is more than 3 mm.
The plug must be accessible after installation.
If the supply lead is damaged, it must be replaced by an equivalent
lead (H05RNF 3x1mm²) available from the after-sales department.
A 16-ampere fuse is necessary.
Your PGF30F fryer uses 2,200 watts. It is therefore absolutely
necessary for your electric wiring system to be able to supply that
power without danger. IT IS VITAL that your fryer is connected to
earth.
IT IS ABSOLUTELY IMPERATIVE TO LEAVE A SPACE OF AT LEAST
5 CM BETWEEN THE BOTTOM OF THE FRYER AND THE FIRST
SHELF OF THE KITCHEN UNIT.
ELECTRICAL CONNECTION
24

1. Installation instructions