Smeg LSAP 6448 Instruction Manual page 18

In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
OPTION SELECTION
Options are selected by pressing the relative button by the symbol of the
option required; the light comes on to confirm that the option has been
activated.
•
•
•
"3/1"
The option is optimised for use of detergents which are complete with
salt and rinse aid, known on the market as "3 in 1", "triple action", etc.
With this option activated, any salt and rinse aid If you wish to use
detergents which already contain salt and rinse aid already in the
dishwasher will not be used.
-
IMPORTANT: when no longer required, the option must be disabled by
pressing the relative button (the light goes out).
If the water hardness has been set on a value above H3, and the "3/1"
option is activated, the relative light flashes, warning of a setting error.
3in1 products are not suitable for use with very "hard" water; this does
not prevent the use of the option, but the washing results might not be
of the best.
16
User instructions
S
TARTING THE PROGRAM
It is not possible to select any options when the soak
program is being used.
All options except "3/1" are disabled at the end of the wash
cycle. To disable the "3/1" option, press the relative button
(the light goes out).
All options, including "3/1" are disabled when a program is
CANCELLED after it has begun.
N.B.: even with the "3/1" option selected, the regenerating
salt/rinse aid lights will still stay on if their containers are empty.
". The program will resume from the