Resetting The Controller - Ledvance LINK DUALSENSOR1AUNVBLE Manual

Resetting the Controller

This component can be reset and restored to factory settings. This will delete all the prior configurations and settings.
When this sensor is not responding, then you may need to reconfigure this device by resetting.
Follow step below to reset the device:
Press the reset button, holding for 3-5 seconds.
After following the above step, the luminaire will blink 3 times to indicate that the device has been successfully reset and factory settings
have been restored.
5-YEAR LIMITED WARRANTY
LEDVANCE warrants the Product to be free from defects in materials and workmanship from date of purchase for
the specified warranty period when used as directed. Failure to comply with Product warnings and instructions
shall void the warranty. This warranty does not cover Product subject to accident, neglect, abuse, misuse, or acts
of God. If Product fails to operate according to the warranty, return Product to place of purchase with proof of
purchase date and LEDVANCE will replace with the same or similar Product free. For additional information,
contact 1-800 LIGHTBULB (1-800-544-4828); Email: lightbulb@ledvance.com. THIS IS THE EXCLUSIVE REMEDY
AVAILABLE. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED. SOME STATES
AND JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU
SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR
PROVINCE.
Information for Users of FCC Part 15, Class B Devices
Compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or experienced radio/TV technician for help.
Modifications: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
CAN ICES-005 (B) / NMB-005 (B)
This Class B digital apparatus complies with Canadian ICES-005
4134402