Advertisement
To set the delay once the program has started, proceed as follows.
If the program you wish to carry out is the same as the one already
in progress:
press the START/PAUSE button (2) for a few seconds, until the
program lights 4 and 5 (marked "end") come on;
annul the program in progress (see relative section) and wait for the
cycle to come to an end;
select the program again;
select the delay required;
press the START/PAUSE button (2) to start the new program.
If the program you wish to carry out is different from the one
already in progress:
press the START/PAUSE button (2) for a few seconds, until the
program lights 4 and 5 (marked "end") come on;
change the program;
select the delay required;
press the START/PAUSE button (2) to start the new program. The
dishwahser will pump out the water and restart with the delay set
and the new program.
22
User instructions
6
8
9 10
11
1
5 7
4
3 2
Advertisement
