Table of Contents
Advertisement
HIGH-TEMPERATURE WARNING LIGHT
Diesel Vehicles Only
The high-temperature warning light (9) is located on the instrument panel below the low oil warning light (8)
(Figure 5, Page 14). The diesel engine is liquid-cooled; if the engine coolant has exceeded its normal safe
operating temperature, the warning lamp will illuminate. If the warning light comes on, stop the vehicle and
allow it to idle for approximately five minutes before stopping the engine. Contact a Husqvarna dealer/distrib-
utor or a trained technician.
ý
WARNING
• Allow the engine to cool before servicing the engine coolant system. Engine coolant can
cause severe burns.
ROLL-OVER PROTECTIVE STRUCTURE (ROPS) AND SAFETY BELTS
The HUV4420 and HUV4420-D vehicles are equipped with a certified Roll-over Protective Structure (ROPS)
and safety belts for each occupant. See following WARNING.
ý
WARNING
• The ROPS must be properly installed before operating the vehicle.
Husqvarna strongly urges that the vehicle's occupants be properly restrained at all times with the safety belts
provided.
Pregnant woman: Consult your doctor for specific recommendations. The safety belt should be worn securely
and as low as possible over the hips and not on the waist.
Injured person: Depending on the injury, first check with your doctor for specific recommendations.
To secure safety belt, sit up straight and well back in the seat. Pull safety belt out of the retractor and insert the
tab into the buckle. A click will be heard when the tab locks into the buckle. Position the lap belt as low as pos-
sible on the hips – not on the waist. (Figure 8, Page 18).
The retractor will lock the belt during a sudden stop. It also may lock if the person leans forward too quickly.
A slow, easy motion will allow the belt to extend, and the person can move around freely. If the safety belt can-
not be pulled out of the retractor, firmly pull the belt and release it. It should then pull smoothly out of the
retractor.
To release the safety belt, press the buckle release button (1) and allow the belt to retract. If the belt does not
retract smoothly, pull it out and check for kinks or twists. Then make sure it remains free of twists as it retracts
(Figure 9, Page 18).
ý
WARNING
• Do not modify the ROPS or operate the vehicle with the ROPS removed. Doing so will void the
certification and could result in property damage, personal injury, or death.
• Do not operate the vehicle if the ROPS is damaged. If the ROPS is damaged, replace the
structure. Do not attempt repair.
• The driver and passenger must be restrained at all times with the safety belts provided to help
prevent injury in the event of sudden braking, collision, or roll-over.
• In the event of a roll-over, do not attempt to jump or otherwise exit the vehicle. Remain seated
with safety belt fastened and with arms and legs inside the vehicle.
WARNING CONTINUED ON NEXT PAGE...
2005 HUV4420 and HUV4420-D Gasoline and Diesel Vehicle Owner's Manual
Roll-over Protective Structure (ROPS) and Safety Belts
Page 17
Advertisement
Table of Contents
