Using Standard Oven Racks; Using Gliding Oven Racks - LG WSEP4723D.BBDLLGA Owner's Manual

16 OPERATION
WARNING
• Do not block the vent opening at the bottom of
the oven.

Using Standard Oven Racks

The racks have a turned-up back edge that
prevents them from being pulled out of the oven
cavity.
CAUTION
• Reposition oven racks before turning the oven
on to prevent burns.
• Do not cover the racks with aluminum foil, or
any other material, or place anything on the
bottom of the oven. Doing so will result in poor
baking and may damage the oven bottom.
• Only arrange oven racks when the oven is cool.
• Do not place objects heavier than 33 lb (15 kg)
on the racks. Do not place heavy objects on the
corners of the racks. Doing so can damage the
racks.
Removing Racks
1
Pull the rack straight out until it stops.
2
Lift up the front of the rack and pull it out.
Replacing Racks
1
Place the end of the rack on the support.
2
Tilt the front end up and push the rack in.

Using Gliding Oven Racks

The optional gliding racks slide in and out on a
frame. This keeps heavy cookware level and
prevents it from sliding forward when the rack is
completely extended.
CAUTION
• Place oven racks in the desired location before
turning on the oven to avoid burns.
• Do not cover the racks with aluminum foil, or
any other material, or place anything on the
bottom of the oven. Doing so will result in poor
baking and may damage the oven bottom.
Installing Gliding Racks
1
Start with the rack in the closed position. Hold
the rack with one hand at the center front and
the other hand at the back right corner.
2
Carefully insert the rack between the rack
guides, and slide it back until the shelf drops
into place.
Rack Guides
a
3
Once the rack is secured in the back, pull the
entire rack forward until the rack locks into
place.
Removing Gliding Racks
1
With the rack in the closed position, grasp the
front of the rack and frame and lift up. Slowly
push the rack towards the back wall until it is
free of the rack stop.
2
After disengaging the rack stop, lift the back
of the rack and pull the rack and frame out
between the rack guides.