Download Print this page
Hide thumbs Also See for WDH-725DG:

Advertisement

Quick Links

Dehumidifier WDH-725DG
Dear customer,
You have chosen a high-quality product. Here are a few tips to help you enjoy this product:
After transportation:
As the appliance works with refrigerant, improper transportation can sometimes occur despite careful instructions on the
packaging. We therefore ask you to leave the appliance upright for at least
4 hours to allow the refrigerant to settle properly in the appliance.
In case of any problems:
We hope that the appliance meets your expectations! Should there be any cause for complaint despite the greatest possible
care, please contact us briefly, as we are very concerned about your satisfaction and would like to clear up any
misunderstanding.
During the first operation:
As the inner pipes come into contact with moisture for the first time, it can take up to approx. 3 hours for liquid to collect in the
collection container, depending on the humidity.
Start-up time / delay:
To protect the compressor, it does not switch on again immediately after the appliance has stopped operating or there has been
an interruption in operation (e.g. emptying the condensation tank). Initially, only the fan runs for one minute. After this minute,
the appliance switches off completely for two minutes and goes into a so-called "protection mode" in which neither the fan nor
the compressor run. Once the two minutes of protection mode have elapsed, the appliance resumes normal operation and runs
with the fan and compressor.
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: info@aktobis.de

Advertisement

loading
Need help?

Need help?

Do you have a question about the WDH-725DG and is the answer not in the manual?

Questions and answers

Summary of Contents for Aktobis WDH-725DG

  • Page 1 "protection mode" in which neither the fan nor the compressor run. Once the two minutes of protection mode have elapsed, the appliance resumes normal operation and runs with the fan and compressor. Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 2 This appliance has parts that must not be replaced or repaired! The refrigerant cannot be renewed or replaced! Do not carry out any repairs or modifications to your device yourself! Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 3 Capacitors must be discharged; this should be done in a safe manner to avoid the possibility of sparking. No live components and wiring must be exposed when filling, restoring or flushing the system. Continuity of the earth connection. Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 4 This is absolutely necessary if soldering work has to be carried out on the pipework. Make sure that the outlet for the vacuum pump is not located near sources of ignition and that ventilation is available. Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de...
  • Page 5 Only electrical heating of the compressor housing may be used to accelerate this process. If oil is drained from a system, this must be done in a safe manner. Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de...
  • Page 6 (value flashes). This can be set in 5% increments from 30% to 90%. After 10 seconds, the value is saved and stops flashing. The current room humidity value is then displayed again. Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 7 When the condensation tank is full, the signal light lights up and the dehumidifier automatically stops dehumidifying. Remove the condensation tank and empty it. After you have pushed the condensation tank properly back into the appliance, dehumidification operation will start again automatically. Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 8 PLEASE REMOVE Fig. 2 Fig. 1 3.5. Correct drainage of condensation water with hose connection! Make sure that the hose always has a slight gradient (see the following diagrams). Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 9 It is best to clean the air filter carefully under lukewarm water or with a vacuum cleaner on a low setting (suction power). (See Fig. 2) Put the cleaned air filter back into its holder - DONE. Fig. 2 Fig. 1 Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 10 (Stone floors, tiles, laminate or parquet flooring, on the other hand, amplify the operating noise of the dehumidifier). Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 11 Damage due to external influences, use of force or foreign objects Damage caused by non-compliance with the operating instructions, e.g. connection to an incorrect mains voltage or non- compliance with the installation instructions Completely or partially dismantled appliances Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...
  • Page 12 They will then recycle the appliance. We hope you enjoy using this device Your Aktobis AG Keep these instructions for use in a safe place! Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany www.AKTOBIS.de Email: info@aktobis.de...