Specifications − High-Static M2 And M3 Chassis - LG Multi V ARNU073M2A4 Installation Manual

GENERAL DATA
Specifications − High-Static M2 and M3 Chassis
Table 5: Ducted High Static M2 and M3 Indoor Unit General Data.
Model No.
Cooling Mode Performance
Capacity (Btu/h)
Max Power Input (W)
1
L/M/H Power Input at Factory Default (W)
Heating Mode Performance
Capacity (Btu/h)
Max Power Input (W)
1
L/M/H Power Input at Factory Default (W)
Entering Mixed Air
Cooling Max. (°F WB)
Heating Min. (°F DB)
2
Unit Data
Refrigerant Type
3
Refrigerant Control
Sound Power dB(A) (H-M-L, @0.24" ESP)
4
Sound Pressure dB(A) (H/M/L, @0.24" ESP)
5
Net Unit Weight (lbs.)
Shipping Weight (lbs.)
Communication Cable (No. x AWG)
6
Fan
Type
Motor
Housing
Motor/Drive
Airflow Rate H/M/L (CFM)
High Mode (Factory Set)
External Static Pressure (in. wg)
High Mode (Factory Set)
Piping
Liquid Line (in., O.D.)
Vapor Line (in., O.D.)
Condensate Line (in., I.D.)
EEV: Electronic Expansion Valve
Power wiring is field supplied and must comply with the applicable local and national
codes.
This unit comes with a dry nitrogen charge.
All capacities are net with a combination ratio between 95-105%.
Rated capacity is certified under AHRI Standard 1230. Ratings are subject to change
without notice. Current certified ratings are available at www.ahridirectory.org.
Max. power input is rated at maximum setting value.
1
Low ambient performance with LGRED° heat technology is included in Multi V 5 Air
2
Source Units produced after February 2019.
14
ARNU243M2A4
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
24,200
430
34 / 43 / 67
27,300
450
34 / 43 / 67
76
59
R410A
EEV
44 / 42 / 42
39 / 38 / 37
82.9
95.5
2 x 18
Sirocco
1
2
Brushless Digitally Controlled / Direct
673 / 512 / 425
0.24
3/8 Flare
5/8 Flare
1
Take appropriate actions at the end of HVAC equipment life to recover, recycle, reclaim or
3
destroy R410A refrigerant according to applicable regulations (40 CFR Part 82, Subpart F)
under section 608 of CAA.
Sound Power level is measured using rated conditions, and tested in a reverberation room
4
per AHRI 260.
5
Sound Pressure levels are tested in an anechoic chamber under ISO Standard 3745.
All communication cable to be minimum 18 AWG, 2-conductor, twisted, stranded, shielded
6
and must comply with applicable local and national codes. Ensure the communication
cable is properly grounded at the main outdoor unit only.
communication cable at any other point.
ARNU283M3A4
28,000
650
60 / 83 / 109
31,500
650
60 / 83 / 109
76
59
R410A
EEV
51 / 50 / 50
40 / 39 / 37
96.1
105.4
2 x 18
Sirocco
1
2
1,250 / 1,017 / 837
0.23
3/8 Flare
5/8 Flare
1
Do not ground the ODU-IDU