General Information - Graco 246857 Instructions Manual

ProComp Turbine Sprayers
The 3800 ProComp turbine, compressor and spray gun
can spray most coatings or finishes currently being used
for automotive refinish, industrial, aerospace, marine,
wood, plastic, and architectural applications.
To produce high-quality paint finishes, the spray gun typ-
ically utilizes inbound air pressure of 6 psi (0.4 bar, 41
MPa). A cone of air, produced by the gun, carries and
directs the paint from the gun to the surface, minimizing
overspray and increasing transfer efficiency. This
enables painters to comply with new, clean air laws that
are designed to reduce VOC (volatile organic com-
pounds) emissions, eases paint application by requiring
fewer paint passes to obtain coverage and saves on
both material and clean-up time.
3800 ProComp Turbine Component Table
System Model
HVLP 3800
ProComp 246857
Huarun
3800 Pro- 249524
Comp
309907G

General Information

30-ft (9 m) Turbine Air Hose
2-qt Remote
30-ft (9 m) Compressor Air
Pressure Pot
287300
287300
See HVLP-Turbine Gun manual 309205 (310750
Korean) for more information on the operation and use
of the turbine spray gun.
Unpacking Turbine
Unpack the Graco Turbine Sprayer from the shipping
carton. Inspect for any possible shipping damage. If
there is any damage, call your distributor.
ProComp Turbine Configuration
The Graco 3800 ProComp is a three-stage turbine
sprayer.
Gun/Fluid Set
Hose
244118
241413 non-bleeder style
250071 pressure fed bun
with 244124 (#3)
244118
241413 non-bleeder style
250071 pressure fed bun
with 244124 (#3)
General Information
Extra Fluid
Sets
244125 (#4)
244126 (#5)
287752 (0.5
mm, #2)
5