Table Of Contents; Safety Precautions For Airless Spraying; Explanation Of Symbols Used; Grounding Instructions - Titan IMPACT X 410 Operation Manual

CONTENTS / SAFETY PRECAUTIONS
1 SAFETY PRECAUTIONS FOR AIRLESS
SPRAYING ______________________________ 2
1.1 Explanation of symbols used _____________________3
1.2 Grounding instructions _________________________3
1.3 Important electrical information __________________3
1.4 Safety hazards ________________________________3
2 GENERAL DESCRIPTION __________________ 5
2.1 PRIME/SPRAY lever ____________________________5
3 OPERATION _____________________________ 6
3.1 Using the gun trigger lock _______________________6
3.2 Pressure relief procedure ________________________6
3.3 Setup _______________________________________6
3.4 Preparing a new sprayer ________________________7
3.5 Preparing to paint _____________________________7
3.6 Painting _____________________________________8
4 SPRAYING TECHNIQUE ___________________ 8
4.1 Cleaning a clogged tip __________________________9
5 CLEANUP _______________________________ 9
5.1 Special cleanup instructions for use with
flammable solvents ____________________________9
5.2 Cleaning the sprayer ___________________________9
5.3 Cleaning the pump filter _______________________10
5.4 Maintenance ________________________________10
6 TROUBLESHOOTING ____________________ 11
ACCESSORIES _______________________________ 32
SPECIFICATIONS ____________________________ 33
WARRANTY _________________________________ 35
2
1
SAFETY PRECAUTIONS FOR AIRLESS
SPRAYING
1.1

EXPLANATION OF SYMBOLS USED

This manual contains information that must be read and understood
before using the equipment. When you come to an area that has one
of the following symbols, pay particular attention and make certain to
heed the safeguard.

This symbol indicates a potential hazard that
may cause serious injury or loss of life. Important
safety information will follow.
This symbol indicates a potential hazard to you

or to the equipment. Important information that
tells how to prevent damage to the equipment
Attention
or how to avoid causes of minor injuries will
follow.

Danger of skin injection

Danger of fire from solvent and paint fumes
Danger of explosion from solvent, paint fumes

and incompatible materials
Danger of injury from inhalation of harmful

vapors

Danger of electric shock
i
Notes give important information which should

be given special attention.
1.2

GROUNDING INSTRUCTIONS

This product must be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current. This product is equipped with a
cord having a grounding wire with an appropriate grounding plug.
The plug must be plugged into an outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING - Improper installation of the grounding
plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect
the green grounding wire to either flat blade terminal. The wire with
insulation having a green outer surface with or without yellow stripes
is the grounding wire and must be connected to the grounding pin.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if you are in doubt
IMPACT X 410