Cleaning and care
Hygiene info
(Cleaning the drum)
Washing at low temperatures and/or us-
ing liquid detergents can cause bacteria
and odours to build up in the washing
machine. Use the Clean machine pro-
gramme to clean the washing machine.
Note the message in the display:
Hygiene info: run a programme at min. 75 °C
or the "Clean machine" programme
Cleaning the water inlet filter
The washing machine has 2 filters to pro-
tect the inlet valve. Check these filters
every 6 months or so. Perform this check
more often if there are frequent interrup-
tions to the external water supply.
Cleaning the filter in the inlet hose
First turn off the stopcock.
Unscrew the inlet hose from the stop-
cock.
Remove the rubber seal 1 from the re-
cess.
Using pointed pliers, take hold of the
plastic filter slat 2 and remove the
plastic filter.
Clean the filter.
58
Reassemble in reverse order.
Cleaning the filter in the inlet valve
Using pliers, carefully loosen the
ribbed plastic nut on the inlet valve
and unscrew it.
Use pointed pliers to withdraw the
plastic filter by the slat.
Clean the filter.
Reassemble in reverse order.
The two filters must be put back in
place after cleaning.
Screw the screw connection securely
back onto the stopcock.
Open the stopcock.
Make sure there is no water leaking
from the threaded union.
Tighten the threaded union.