Table of Contents
Advertisement
Insert "Control board FFC" into
S18
"Interface board" and paste it on Main
SHD
Assemble "Rear Cover" with "Middle
S19
Frame" according to the sequence
shown in the picture
Lock 4 screws to fix "Rear Cover"
(Screw Torque: 9±1 kgf)
Insert the stand base blocks fully into
S20
the stand slot
Lift the screw handle and turn the screw
clockwise
After fully tightening the screw, fold the
screw handle flat within the recess
Attach the stand assembly to the
S21
display
a. Fit the two tabs on the upper part of
the stand to the groove on the back
of the display
b. Press the stand down till it snaps into
place
- 18 -
Advertisement
Table of Contents
