Yamaha FJR1300AE 2023 Owner's Manual page 29

In this case, push the select switch to
switch the display in the following or-
der;
TRIP-F → Display–1 → Display–2 →
Display–3 → TRIP-F
To reset a tripmeter, use the select
switch to select the information display
that contains the tripmeter you want to
reset. Push the "RESET" button briefly
so that the tripmeter flashes, and then
push the "RESET" button again for 2
seconds while the tripmeter is flashing.
If you do not reset the fuel reserve trip-
meter manually, it will reset automati-
cally after refueling and traveling 5 km
(3 mi).
Estimated traveling range display:
RANGE
The distance that can be traveled with
the remaining fuel in the fuel tank under
the current riding conditions is shown.
Elapsed time display:
TIME TRIP
The time that has elapsed since the key
was turned to "ON" is shown. The
maximum time that can be shown is
99:59.
This timer automatically resets when
the key is turned to "OFF".
Instrument and control functions
mile
27
0:06
4-12
TIP
There are also "TIME–2" and "TIME–3"
elapsed time displays, but they cannot
be set to the information display. See
"Setting mode" on page 4-14 for de-
tailed information.
Air temperature display:
A.TEMP
This display shows the air temperature
from 16 °F to 122 °F in 1 °F increments.
The temperature displayed may vary
from the actual ambient temperature.
TIP
 16 °F will be displayed even if the
ambient temperature falls below
16 °F.
 122 °F will be displayed even if the
ambient temperature
above 122 °F.
Coolant temperature display:
C.TEMP
The coolant temperature display indi-
cates the temperature of the coolant.
The coolant temperature varies with
changes in the weather and engine
load.
If the message "Hi" flashes, stop the
vehicle, then stop the engine, and let
the engine cool. (See page 7-39.)
˚F
77
4
climbs
˚F
Lo