Advertisement
TO OPERATE:
1. Remove cover from sink opening and turn on a good flow of COLD water. It is
absolutely necessary that cold water flows into the disposer while it is in oper¬
ation, (Cold water hardens greasy substances, making it easy to grind them into
tiny particles. Cold water also keeps grease from sticking to the drain lines.) If
you have a double sink, make sure the faucet is positioned to the side where
the disposer is installed during operation of the disposer.
2. Scrape food waste into disposer opening. Mix soft and hard food waste items
for most efficient grinding.
3. For maximum safety, to minimize the possible ejection of materials while grinding,
after all food waste has been fed into the disposer, place the cover in the
DRAIN/GRIND position (see illustration).
A WARNING
Personal Injury Hazard
Do not put hands into disposer. Failure to do so can
result in personai injury._
4. Turn wail switch to ON position.
5. Allow both the disposer and cold water to run after grinding is completed to help
flush out drain pipes. Ground waste and water flow at an approximate rate of
2 seconds/foot in a pitched horizontal drain pipe. The water flow time after
grinding will depend on the quantity of ground food waste and the length of
horizontal drain pipe.
6. Turn wall switch to OFF position. Turn off water.
OPERATING INSTRUCTIONS FOR
BATCH FEED MODEL
KitchenAid Superba (Model KBDS250j
The KitchenAid batch feed disposer has a built-in ON/OFF switch which is operated
by the cover.
TO OPERATE:
1. Remove the cover and scrape food waste into disposer opening. Mix soft and
hard food waste items for most efficient grinding.
2. Turn on a good flow of COLD water. (Cold water hardens greasy substances,
making it easy to grind them into tiny particles. Cold water also keeps grease
from sticking to the drain lines.) It is absolutely necessary that cold water flows
into the disposer while it is in operation. If you have a double sink, make sure
the faucet is positioned to the side where the disposer is installed during oper¬
ation of the disposer.
3. Place the cover back into the sink sleeve in the SEAL position. Lift up the cover
handle slightly and turn it to the right or left until the disposer starts.
4. Allow both the disposer and cold water to run after grinding is completed to help
flush out drain pipes. Ground waste and water flow at an approximate rate of
2 seconds'foot in a pitched- horizontal drain pipe. The water flow time after
grinding will depend on the quantity of ground food waste and the length of
horizontal drain pipe.
5. Turn handle to the right or left to stop disposer. Turn off water.
Advertisement
