Turntable Installation - Binatone MWO-2520 Instruction Manual

Cabinet: Remove any protective film found on the microwave oven
cabinet surface.
Do not remove the light brown Mica cover that is attached to the oven inside
cavity to protect the magnetron.
•
Before using it for the first time, clean and dry the appliance thoroughly as
described in the "CARE AND MAINTENANCE" section.
•
Always operate the appliance on a dry, flat and stable working surface.
•
Note: If the appliance is not in use, always set the timer to "0".
OPERATING INSTRUCTIONS
INSTALLATION
30cm
0cm
20cm
min 85cm
Select a level surface that provides enough open space for the intake and/or
outlet vents.
a) The minimum installation height is 85cm.
b) The rear surface of appliance can be placed against wall.
Leave a minimum clearance of 30cm above the oven, a minimum clearance
of 20cm is required between the oven and any adjacent walls or items.
c) Do not remove any of the legs from the bottom of the oven.
d) Blocking the intake and/or outlet openings can damage the oven.
e) Place the oven as far away from radios and TV as possible. Operation of
microwave oven may cause interference to your radio or TV reception.
WARNING: Do not install the oven over a cooking range or other heat-producing
appliance. If installed near or over a heat source, the oven could be damaged and
the warranty would be void.
Note: The appliance must not be installed behind a decorative door in order to
avoid overheating. (This is not applicable for appliances with decorative door.)

TURNTABLE INSTALLATION

Please refer to FIG. A for the installation of the turntable and note the followings:-
a. Never place the glass tray upside
down. The glass tray should never
be restricted.
b. Both glass tray and turntable ring
assembly must always be used
during cooking.
c. All food and containers of food are
always placed on the glass tray
for cooking.
d. If glass tray on turntable ring assembly
cracks or breaks, contact your nearest
authorized service center.
20cm
FIG.A
Glass tray
Turntable shaft
5
Hub (underside)
Turntable ring assembly