Changing The Brake Pads; Wear Of The Wheel Rims; Adjusting The Gear Changing System - wayscral 71604 Manual

•
The brake pads are standard, replace them when your pad no longer has any friction.
•
The reference of the brake pad mounted on your bicycle is as follows:
Model: DSK 300 ;
Reference: PD071S
Do not forget that the new brake pads must be run in. They are run in by riding a few minutes and
activating the brakes, alternatively with sudden stops and light braking.
2.

Changing the brake pads

- Disk brake
Remove the wheel and remove the old pads from the brake calliper. Position the new pads in the
calliper so that the braking surfaces touch. Do not touch the braking surfaces. Insert the pads one at a
time in the brake calliper.
Then adjust the brakes according to the previous paragraph (IV.1.)
3.

Wear of the wheel rims

As any other part that is subject to wear, the wheel rim should be checked regularly. The wheel rim
can weaken and break, causing you to lose control and fall.
V.

Adjusting the gear changing system

Your bicycle has several manually interchangeable speeds with a
Shimano RevoShift system with a rear derailleur. Use the right
handle to make the desired change.
The higher the indicator, the more difficult it will be to pedal and
vice versa.
Careful, never pedal backwards while changing gears and never
force the command lever.
For an optimum use of the gear-changing system, we recommend
avoiding changing gear other than during heavy pedalling sessions.
45