Smeg DC146L Instruction Manual page 18

CHANGING A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see "I
•
select the new program;
•
start the program (see "S
ANNULLING A PROGRAM
To annul the program
•
press the START/PAUSE button (3 ) for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
•
Keep the START/PAUSE button (3) pressed until the PROGRAM
PHASES lights (5) go out (confirmation beep). "
the DISPLAY and pump-out of the water in the tank will begin,
ending the program at the point where it was interrupted. When the
operation is complete, the PHASES/PROGRAM LIGHTS (5) flash.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted. When the operation is complete, the
PROGRAM PHASES lights (5) flash.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 60 seconds later.
16
User instructions
TARTING THE PROGRAM
S
TARTING THE PROGRAM
NTERRUPTION A PROGRAM
").
P0
". The program will resume from the
");
" will appear on