Smeg DC146L Instruction Manual page 17

User instructions
STARTING THE PROGRAM
To start the dishwasher, press the START/PAUSE button (3) for a few
seconds, until the light of the first phase of the selected program starts to
flash (confirmation beep).
As the program runs, the PHASES/PROGRAM lights (5) will indicate the
current cycle status.
The light of the phase in progress will flash, while the lights of the
subsequent phases remain on.
END OF PROGRAM
At the end of the program, a short beep sounds, the word "End" appears
on the DISPLAY (9) and the PHASES/PROGRAMS (5) lights flash.
Pressing the SELECTION PROGRAMS (2) button clears the word "End"
from the display and the dishwasher is ready for a new cycle.
INTERRUPTION A PROGRAM
To interrupt a program in progress:
•
press the START/PAUSE button (3 ) for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
•
you may now restart the program by pressing button (3) again until it
restarts, or change or annul the program (see "C
", or "A
PROGRAM NNULLING A PROGRAM
").
HANGING A
15