Table of Contents
Advertisement
better control of the product and the position of the
kickback zone.
•
To cut on the push stroke is when you cut with the
top of the guide bar. The saw chain pushes the
product in the direction of the operator.
WARNING:
caught in the trunk, the product can be
pushed at you. Hold the product tightly
and make sure that the kickback zone
of the guide bar does not touch the tree
and causes a kickback.
To use the cutting technique
WARNING:
cut and decrease the speed to idle speed
after each cut.
1065 - 010 - 08.02.2024
If the saw chain is
Use full power when you
CAUTION:
for too long without load. This can cause
damage to the motor.
1. Put the trunk on a saw horse or runners.
WARNING:
pile. That increases the risk of kickback
and can cause serious injury or death.
2. Remove the cut pieces from the work area.
WARNING:
area increase the risk of kickback and
that you cannot keep your balance.
To use the spiked bumper
1. Push the spiked bumper into the trunk of the tree.
2. Apply full power and rotate the product. Keep the
spiked bumper against the trunk. This procedure
makes it easier to apply the force necessary to cut
through the trunk.
To cut a trunk on the ground
1. Cut through the trunk on the pull stroke. Keep full
power but be prepared for sudden accidents.
WARNING:
chain does not touch the ground when
you complete the kerf.
Do not let the motor operate
Do not cut trunks in a
Cut pieces in the work
Make sure that the saw
19
Advertisement
Table of Contents
